LM Micro ball trackDescription：采用左右各1列滚道的精巧设计，体积小、轻量化，特别适合小型化设备使用
- Cname：Linear Guide Rail
- Date：2020-01-13 17:41:02
1. It adopts the delicate design of one row of raceway on the left and right, which is small in volume and light in weight, especially suitable for the use of miniaturized equipment.
2. The groove is designed as Gothic structure, and its contact angle is 45 degrees, so it has equal rigidity and load capacity in four directions.
3. LMW series is suitable for single rail because of its wide range, high rigidity and large load capacity in transverse torque.
LM7 and LM9 models also have the following features:
1. A part of the main body of the sliding block is made of resin material, which reduces the weight of the ordinary sliding block by 25% and has less inertia
2. The sliding block parts are interlocked to make the structure closer and the steel ball circulation smoother.
3. With a holding wire to prevent the ball from falling off, the ball will not fall off even if the slider is taken off the guide rail.
The guide rail, slide block, steel ball and holding steel wire are all made of stainless steel with good corrosion resistance.
- The reason and solution of noise in the running of linear guide rail 2019-11-11
- How to clean the linear guide? 2019-05-22
- Basic knowledge of linear guide 2019-05-22
- Four points for attention in installation of linear guide rail 2019-11-11
- How to select the linear guide correctly 2019-05-22
- Choosing the right linear guide needs to look at these! 2019-12-31
- Introduction to linear guide 2019-05-22
- Working principle of linear guide 2019-05-22
- Precautions and troubleshooting of linear guide 2019-05-22
- Installation procedure of linear guide rail 2019-05-22