Attention to automatic operation of linear slide

1. Please set up the safety fence at the movable range of the linear slide.

2. At the entrance of the safety fence, please design the emergency switch device.

3. Please try not to enter or exit from the entrance other than the relevant emergency switch device.

Pay attention to pinching hands

1. When operating the linear slide, please be careful not to enter the movement range of the module with hands or other objects.

Operating instructions

1. Before the installation of linear sliding table, it is necessary to read the operation instructions and the prompts in the installation instructions for operation.

2. If the installation, adjustment, inspection, maintenance, operation, etc. are not written in the operation manual, please consult the after-sales service about how to operate. If not, try it without permission.

Do not use in combustible gas and other environment

1. There is no explosion-proof specification for linear slide.

2. Do not use in combustible gas, combustible powder, igniting liquid and other environments.

It is forbidden to use it in case of possible electromagnetic injury, etc

1. Please do not use it in electromagnetic injury, electrostatic discharge, infinite magnetic wave and other occasions.

Precautions for vertical installation of linear slide brake

1. Before releasing the brake, block the upper and lower axles with a stop or other objects.

Safety precautions for protective block (bump block)

1. The protective block is designed and installed to prevent the loss or change of power (power, air pressure, etc.) from causing danger.

2. The protective block may be dangerous when the object is dropped. For the investigation of the size, weight, temperature and chemical properties of the object, appropriate safety supervision test shall be taken.

Precautions for controller inspection

1. In order to prevent static electricity, please cut off the controller link when checking the controller, contacting the external terminal of the controller or connecting wire post.

2. Do not touch the inside of the controller.

Handling the loss and abnormality of linear slide

1. In case of any abnormality or loss, please stop using immediately and contact after-sales technical personnel.

Precautions for high temperature of motor and reducer

1. High temperature may occur when the motor and reducer are running. When checking the linear slide, make sure that the motor and reducer stop rotating and contact again when the temperature drops.

No removal, alteration and damage warning signs

1. Do not remove warning signs without permission.

2. Do not block warning signs with nearby machinery or objects.

3. Make sure that the pattern of the warning sign and the text can be seen from outside the safety fence.

Electrostatic protection

Make sure that the linear slide and controller are grounded.